MIKROE LDC 2 Click

MIKROE LDC 2 Click is a compact add-on board that measures inductance change which a conductive target causes when it moves into the inductor's AC magnetic field. This board features the LDC1041 inductance-to-digital converter (LDC) for inductive sensing solutions from Texas Instruments. This Click board™ is easy-to-use requiring only the sensor frequency within 5kHz and 5MHz to begin sensing and demonstrates the use of inductive sensing technology to sense and measure a conductive target object's presence position or composition. It comes with an example of a PCB sensor coil designed to provide the user with maximum flexibility. This Click board™ is suitable for contactless short-range sensing that enables high-resolution and low-cost position sensing of conductive targets even in harsh environments. LDC 2 Click is supported by a mikroSDK compliant library which includes functions that simplify software development. LDC 2 Click as its foundation uses the LDC1041 an inductance-to-digital converter that simultaneously measures an LC resonator's impedance and resonant frequency from Texas Instruments. This Click board™ is easy-to-use requiring only the sensor frequency within 5kHz and 5MHz to begin sensing and demonstrates the use of inductive sensing technology to sense and measure a conductive target object's presence position or composition. In addition the LDC1041 also measures the oscillation frequency of the LC circuit used to determine the inductance of the LC circuit. The device then outputs a digital value that is inversely proportional to frequency. The LDC measures the inductance change that a conductive target causes when it moves into the inductor's AC magnetic field to provide information about the target's position over a sensor coil. The inductance shift is caused by eddy currents (circulating currents) generated in the target due to the sensor's magnetic field. These eddy currents generate a secondary magnetic field that opposes the sensor field causing a shift in the observed inductance used for precise positioning of the target as it moves laterally over the sensor coil. Also the LDC1041 has two power modes: Active and Standby Mode. In Active Mode the proximity data and frequency data conversion are enabled while Standby mode represents the default mode on devices' Power-Up sequence. In Standby Mode the conversion process is disabled. This Click board™ comes with an example of a PCB sensor coil designed to provide the user with maximum flexibility. The LDC1041 communicates with MCU using the standard SPI serial interface with a maximum frequency of 4MHz. In addition to this serial interface one GPIO pin connected to the mikroBUS™ socket is also used. The configurable interrupt pin routed to the INT pin of the mikroBUS™ socket may be configured in three different ways by programming the interrupt Terminal mode register with SPI. An interrupt pin provides the ability to act as a proximity switch as a wake-up feature or as a data-ready pin indicating a valid condition for new data availability. This Click board™ operates only with a 5V logic voltage level. The board must perform appropriate logic voltage level conversion before use with MCUs with different logic levels. However the Click board™ comes equipped with a library containing functions and an example code that can be used as a reference for further development.