Bitrunner V2 - Standard

BitRunner allows Carbide Motion to control power to your router without the need for you to reach for the power switch each time a program ends or each time a tool change is required.This new version of BitRunner includes a new lockout pendant so you can manually disable the router during bit changes for additional safety.Standard vs. DeluxeBitRunner Deluxe includes an internal AC filter to better keep electrical noise from leaving the router and entering the AC power lines in your shop. If you've got funky AC wiring in your shop or you've seen EMI-related disconnects then we recommend BitRunner Deluxe.Can I use it to control my Shop Vac?No BitRunner is only for the router. Connecting a Shop Vac to BitRunner will likely overload the internal circuit. It is also likely to cause electromagnetic interference with both motors turning on and off at the same time.Does this work with a VFD spndle?No BitRunner is only for routers. VFD spindles are controlled by their own electronics.CompatibilityBitRunner is compatible with all Shapeoko Pro Shapeoko 4 and Shapeoko 5 Pro machines with a Carbide Compact Router. It is not compatible with VFD spindles or the Shapeoko HDM.If you have Shapeoko 3 with a V2.3 board and below (Shapeoko 3 machines purchased before Black Friday 2019) you will need to add the Carbide Motion PCB with an enclosure which includes a new circuit board with the BitRunner connector installed. If you have a Shapeoko 3 with a V2.4 PCB please take a picture of it and email support to confirm that it will work as-is.Instructions can be found here