Adafruit VL53L5CX Time-of-Flight Distance 8x8 Pixel Camera
The Adafruit VL53L5CX Time of Flight Sensor takes the great Time of Flight distance sensor technology we've seen from ST in the VL5 series of chips, and gives you a full grid of 8x8 sensor squares. This means we don't just measure up to 4 meters away, you also get to divide the measurement cone into 64 spots and get the individual distance for each. This makes it more like a depth camera than a sensor, albeit not a very high resolution one.
The sensor contains a very tiny invisible laser source, a fixed 8x8 diffractive optic lens, and 64 matching sensors. The VL53L5CX can detect the "time of flight", or how long the light has taken to bounce back to the sensors. The optics and laser are tuned and narrow so you get nice and crisp measurements from each grid point. Unlike sonars that bounce ultrasonic waves, the 'cone' of sensing is very narrow. Unlike IR distance sensors that try to measure the amount of light bounced, the VL53 is much more precise and doesn't have linearity problems or 'double imaging' where you can't tell if an object is very far or very close.
The earlier series of VL53 sensors (VL53L0, VL53L1, VL53L3, and VL53L4) have a variety of ranges and field-of-view but only do one zone. This one does way more, and you have to load in the firmware so you definitely cannot use 'small memory' boards like the ATmega328 - you'll need a SAMD21, SAMD51, ESP, etc chip with more than 128K of flash memory and over 16K of SRAM! It also takes longer to start up than simpler ToF sensors, about 3 seconds cold-boot, since you have to load in that firmware.
However, as long as you have a big-enough chip, the sensor is small and easy to use in any robotics or interactive project. As it needs 3.3V power and logic we put the little fellow on a breakout board with a regulator and level shifting. You can use it with any 3-5V power or logic microcontroller with no worries. Works great with the 3.3V logic level of a Feather, or the 5v level of a Arduino Mega, this breakout is ready to work with most common microcontrollers or SBCs. and since it speaks I2C, you can easily connect it up with two data wires plus power and ground.
As if that weren't enough, we've also added SparkFun qwiic compatible STEMMA QT connectors for the I2C bus so you don't even need to solder. Just wire up to your favorite micro with a plug-and-play cable to get ToF data ASAP. For a no-solder experience, just wire up to your favorite micro, like the STM32F405 Feather using a STEMMA QT adapter cable. The Stemma QT connectors also mean the VL53L4CX can be used with our various associated accessories. QT Cable is not included, but we have a variety in the shop
Communicating to the sensor is done over I2C with an API written by ST, we have two Arduino libraries, one that uses the ST package and one that is "NoST", and perhaps easier to port to a new platform. Please note that the demo above shows performance on an ESP32-S3 Feather and we do a 16x16 bicubic interpolation.
EN