IT
BMP085 Breakout(Discontinued)
MEPA CODE:
01231143
BRAND:
DFRobot
MANUFACTURER CODE:
SEN0120
SKU CODE:
DF-SEN0120
19,45
€
(excl. VAT)
Full description
Introduction
BMP085 Breakout is discontinued now. We recommend these IMU Sensors as suitable replacement where you might find some other alternatives.
This is a simple breakout board for the BMP085 high-precision, low-power barometric pressure sensor from DFRobot. The BMP085 offers a measuring range of 300 to 1100 hPa with an absolute accuracy of down to 0.03 hPa. It's based on piezo-resistive technology for EMC robustness, high accuracy and linearity as well as long term stability. This sensor supports a voltage supply between 1.8 and 3.6VDC. It is designed to be connected directly to a micro-controller via the I2C bus This breadboard-friendly board breaks out all pins of the BMP085 to a 6-pin 0.1" pitch header. The analog and digital supplies (VDDD and VDDA) of the BMP085 are tied together and broken out to a single pin. We've also put two 4.7k pull-up resistors on the I2C lines.
Project 1: NodeMCU IoT Environment MonitorThis NodeMCU IoT project is a simple demonstration on how to send sensor data to the Internet. Hardware Needed:SHT1X Temperature and Humidity SensorBMP085 Atmospheric Pressure Sensor
Specification
BMP085 Breakout is discontinued now. We recommend these IMU Sensors as suitable replacement where you might find some other alternatives.
This is a simple breakout board for the BMP085 high-precision, low-power barometric pressure sensor from DFRobot. The BMP085 offers a measuring range of 300 to 1100 hPa with an absolute accuracy of down to 0.03 hPa. It's based on piezo-resistive technology for EMC robustness, high accuracy and linearity as well as long term stability. This sensor supports a voltage supply between 1.8 and 3.6VDC. It is designed to be connected directly to a micro-controller via the I2C bus This breadboard-friendly board breaks out all pins of the BMP085 to a 6-pin 0.1" pitch header. The analog and digital supplies (VDDD and VDDA) of the BMP085 are tied together and broken out to a single pin. We've also put two 4.7k pull-up resistors on the I2C lines.
Project 1: NodeMCU IoT Environment MonitorThis NodeMCU IoT project is a simple demonstration on how to send sensor data to the Internet. Hardware Needed:SHT1X Temperature and Humidity SensorBMP085 Atmospheric Pressure Sensor
Specification
- Digital two wire (I2C) interface
- Wide barometric pressure range
- Flexible supply voltage range
- Ultra-low power consumption
- Low noise measurement
- Fully calibrated
- Temperature measurement included
- Ultra-flat, small footprint
- Dimensions:16 x 16 mm (0.63 x 0.63")
- BMP085 Breakout x1
- Arduino library
- Example Arduino Sketch
- Example Code (ATmega328)
- Wiring Example
- mbed User Review
Additional images