Gravity: Bright LED Module

Introduction
The Bright LED module is designed for some special application. It's using a very bright LED component as its light source. Compatible with DFRobot gravity 3-Pin interface, plug and play. What you need is just a digital signal, you can drive it directly. Besides, the LED is so bright that do not stare at the LED in case of any eye damaging!

Project 1: Annoying Soil Moisture Sensor with Photon and IFTTT Project

Never forget to water your plants again with this super annoying project. It combines visual, auditory, and textual cues that will prevent you from doing anything else until you provide your plant with much-needed hydration. A piezo buzzer constantly blares a shrill note, while a super-bright LED annoys your peripheral vision. In addition, this project will send constant texts to your phone reminding you that your plant needs to be watered. Sounds like fun, right?

Hardware Components:

• Digital Buzzer For Arduino
• Bright LED Module
• Analog Capacitive Soil Moisture Sensor
• Particle Photon
• Micro USB Cable
• 400 Tie Point Interlocking Solderless Breadboard
• Arduino Jumper Cables (M/M) (65 Pack)

• Operating Voltage: 5VDC
• Opearting Current: 20mA (Max)
• Dimension: 30*22(mm)/ 1.18”*0.87”(in)

• Bright LED Module x1
• Gravity 3-Pin Cable x1

• Product WIKI