0.8 Inch 16 Segment LED White - Common Anode

This is a 16 segment common cathode LED and is white. The advantage of 16 segment is that you can not only display 1234567890, but also ABCDEFGHIJKLM.   It is compatible with bread board and can work with Arduino by adding some current limiting resistors. So, it Suitable for people who is newbie of electronic.   Note: It just a segment LED without control chip.   Features High Light low current low-voltage low energy Longevity IC-compatible   Specification 0.80 inch common port: 11 size: 20.0 x 27.7 x 8.5mm Colors: white surface colors: Black Working temperature: -20~60°C   Mechanical Outline： Unspecified Tolerances is: X±0.2         Absolute Maximum Ratings  

Parameter	Symbol	Maximum Rating	Unit
Power Dissipation	Pd	-	mW
Peak Forward Current	Ifp	150	mA
Continuous Forward Current	Ifm	20	mA
Reverse Voltage	VR	5	V
Operating Temperature Range	topr	-40 → +85	℃
Storage Temperature Range	Tstg	-40 → +100	℃
Static Voltage	Var	-	V

* Lead Sodering Temperature：260℃  for 3 seconds * For  operation above 25℃,  The Ifm Ifp & Pd must be derated, the Curent derating is –0.36mA/℃ for  DC drive and  -0.86mA/℃ for Pulse drive, the power dissipation is  -0.75mW/℃. The product working current must not more than the 60% of the Ifm or Ifp according to the working temperature.     Optical-Electrical Characteristic  

Parameter	Test CONDITING	Symbol	Min	Type	Max	Unit
Luminous Intensity	IF=10mA	Iv	80.5	85.5	89.7	Mcd
Forward Voltage	IF=10mA	VF	-	3.0	-	V
REVERSE Current	VR = 5V	IR	-	80		uA
Peak Wavelength	IF=10mA	λp	461.3	465.2	468.7	nm
Spectral Bandwidth	IF=10mA	△λ	-	40	-	nm
View Angle	IF=10mA	2θ1/2	-		-	Deg.

  Storage & Soldering Condions: Store with care. Storing the units in bad condition will cause the reflector sheet and decrease it’s adhesive  power. Storage  the  products  under  the condition :temperature ( 25℃ ± 10℃ ) and humidity (65℃ CRH±20℃ CRH) our recommendation.                                       The Soldering Temperature is 260±5℃ and Soldering Time should be less than 3 sec, and soldering iron power should be less than 30W.                                            The soldering point should be farther than 1.6mm from boby. 

 

  For any technical support or suggestion, please kindly go to our forum.